Specifications

The CLI Command Interface Nur für den internen Gebrauch
A31003-H3580-M103-2-76A9, 01-2009
D-14 HiPath 3000/5000 V8 - HG 1500 V8, Administrator Documentation
hg-d.fm
Start command line
D.7.1 Rebooting
HG 1500 can be restarted via the standard Reset command line or via the WBM Reset button.
The boot procedure can be interrupted by pressing any key on the keyboard of a terminal con-
nected to the V.24 interface.
D.7.1.1 Initiating Reboot
To reboot an already operating HG 1500:
● Key combination
Press <CTRL>+<x> at the same time.
● WBM input
Click the Reset icon.
● Command line
Enter the Reset command on a terminal connected to the V.24 interface or alternatively
on a Telnet terminal.
In all of these cases, the gateway will restart with the current configuration.
D.7.1.2 Boot sequence
The firmware performs the following tasks during booting:
1. It initializes the hardware components of the board.
2. It tests the hardware components (module test). The Boot ROM displays the results of the
integrated self-test as well as information on the boards and the current start parameter
("Boot Line"). A three-second countdown is subsequently performed and displayed on the
screen. The boot procedure can be interrupted during the countdown by pressing any key
on the terminal connected to the V.24 interface.
3. Once the count down has ended, the system loads the software image from the flash mem-
ory into RAM and starts it.
4. Starting the software image activates all hardware components, initializes the kernel, con-
figures the TCP/IP stack (using the IP address given in the start parameters) and links the
driver to the kernel.
5. The Boot ROM starts a checking process to monitor the gateway. If this process deter-
mines that the gateway is hanging, it will reboot automatically with the current configura-
tion.