Specifications

The CLI Command Interface Nur für den internen Gebrauch
A31003-H3580-M103-2-76A9, 01-2009
D-16 HiPath 3000/5000 V8 - HG 1500 V8, Administrator Documentation
hg-d.fm
Start command line
Boot commands can only be specified via a terminal that is connected to the V.24 interface.
They are not available in Telnet sessions.
y Formats TFFS. You are requested to specify if "Low level" formatting should
be performed (recommended if there are serious problems. "Low level" for-
matting takes longer than standard formatting).
z Writes the start parameters to TFFS.
C Modifies the directory.
D Deletes a file from the TFFS.
L Lists the contents of the current TFFS directory.
N Creates a new TFFS directory.
0 Specifies the device addresses of the network interfaces.
P Displays the path for the current directory.
R Deletes a directory.
T Creates a file with any desired name (0 bytes in length) in the TFFS, enabling
specific "switch" files to be created for more thorough error detection by the
developer.
W Loads a file and copies it to TFFS (per TFTP).
X Proceeds with auto-boot operation (<CTRL> + x initiates a warm start).
# These commands can be used to correct a faulty RAM disk during a restart.
The gateway behaves in the same way as when disconnecting and recon-
necting (for debugging only).
*
? Shows help on the commands.
@ Starts the system (loads and executes software).
Command Description
Table B-2 Boot Commands