Specifications

The CLI Command Interface Nur für den internen Gebrauch
A31003-H3580-M103-2-76A9, 01-2009
D-18 HiPath 3000/5000 V8 - HG 1500 V8, Administrator Documentation
hg-d.fm
Start command line
D.7.2.3 Editing Start Parameters
If c is specified in the command line, the first current start parameter is displayed (for example:
boot device emac0). To modify this value, specify the new value after the value displayed
and press the return key to save the updated value.
The following commands are available for navigating within the command line and for editing
entries.
After entering all parameters, press z to save the updated values.
D.7.3 Software Installation using the Boot CLI
Proceed as follows to correctly install the software using the Boot CLI:
D.7.3.1 Preparations
● The TFTP server is available. A self-extracting file (*.inst) containing the software image is
available on the server in a known directory. This file automatically installs the software dur-
ing system startup.
● A console is connected to the V.24 interface.
Command Description
. Entering a point deletes the content of the line.
<ENTER key> Pressing the Enter key displays the next parameter line.
- Entering a minus sign displays the contents of the previous pa-
rameter line.
<CTRL>+<d> Inputting <CTRL>+<d> terminates the editing process for start pa-
rameters.
Table B-4 Commands for Editing Start Parameters
>
If the start parameters were modified with the c command but not saved, only the
RAM data is changed. The modified data is only used for the next boot procedure.
The changes are only saved to the flash memory after successful startup using the
modified parameters.