Specifications

hg-d.fm
A31003-H3580-M103-2-76A9, 01-2009
HiPath 3000/5000 V8 - HG 1500 V8, Administrator Documentation
D-19
Nur für den internen Gebrauch
The CLI Command Interface
Start command line
D.7.3.2 Loading the Software to the Flash Memory
1. Press any key on the connected console keyboard if the message "Press any key to
stop auto-boot..." is displayed on the terminal. The session then starts as for the root
administrator and requests a password (but only if this has previously been configured).
2. Enter a valid password.
3. Press c and change the start parameters to the following values:
4. Once you have changed the start parameters, enter the w command.
5. Enter the extension 001 at the prompt. The file name is now SW_IMAGE.001. Confirm with
y.
6. Wait until the data transfer is complete. If errors occur, check the values of the start param-
eters and the LAN cable connection and make sure that the FTP or TFTP server is opera-
tional.
7. Once the data has been transferred you will be asked if the changes made to the start pa-
rameters are to be saved. Press y to save your changes.
Parameters Value
boot device emac0
processor number 0
host name Name of the TFTP or FTP server.
file name File name of the software image (e.g. X_CG25_C.001).
inet on ethernet (e) IP address of the HiPath HG 1500 including the subnet mask as
a hexadecimal number
inet on backplane (b) No changes required.
host inet (h) IP address of the TFTP or FTP server.
gateway inet (g) Gateway IP address, via which the TFTP or FTP server can be
reached (optional).
user (u) FTP access name.
ftp password (pw) FTP password.
flags (f) In the case of FTP: 0x00, in the case of TFTP: 0x80
target name (tn) Name of the HiPath HG 1500.
startup script (s) Startup script.
other (o) emac
Table B-5 Start Parameters for Software Installation via Boot CLI