Specifications

4 Communication settings and guide of HMI connecting with controller
  The transmission speed of port 1 will be set with DIP 3, 4 switches
o 3 on, 4 off is 19200 bps
  The transmission speed of port 2 will be set with DIP 6, PHL switches.
o 6 off, PHL on is 19200 bps
MicroEH
  The transmission speed will be set with DIP switches
o SW1 on is 19200 bps
  Which procedure(1 or2) to use by judging the value of the WR F01A.Different with EH150, The
highest bit of WR F01A is optional, The data will reset when turn on the power again. If the value of R
7F6 is set on, the data of WR F01A will be stored in Flash memory.
o 0x0000 for procedure 1.
o 0x8000 for procedure 2.
Note: if procedure 2 is set and written in Flash memory, external device (only supports procedure 1) or
ladder editor will not connect with it.
S10V
Device
Bit Address
Word Address
Format
Notes
S S 0-BFF ------ HHH
Z
Z 0-3FF
------
HHH
E
E 0-FFF
------
HHH
V V 0-FFF ------ HHH
P P 0-7F ------ HH
N N 0-FF
------ HH
CCC CCC 0-FF
------ HH
CR CR 0-FF
------ HH
CD CD 0-FF
------ HH
CU CU 0-FF
------ HH
UUU UUU 0-FF
------ HH
UU UU 0-FF
------ HH
TTT TTT 0-1FF
------ HHH
TT TT 0-1FF
------ HHH
K K 0-FFF
------ HHH
M M 0-FFF
------ HHH
R R 0-FFF
------ HHH
G G 0-FFF
------ HHH
Q Q 0-FFF
------ HHH
Y Y 0-FFF
------ HHH
J J 0-FFF
------ HHH
X X 0-FFF
------ HHH
OW ------ OW 0-FFF
HHH
IW
------
IW 0-FFF
HHH
- 112 -