Specifications

4 Communication settings and guide of HMI connecting with controller
NOTE: If the servo controller to modify the station number, the servo power needed to restart, the station
number to take effect, otherwise the communication is incorrect.
RS485 communication
◎Supported Device
Device
Bit Address
Word Address
Range
Notes
word
————
20
Refer to the kinco manual
word
————
10
Refer to the kinco manual
word
————
8
Refer to the kinco manual
NOTE: Use the touch screen, pay attention to the rules addressing. The specific reference to the following
description.
Touch-screen type of address: according to the number of bits to the servo. Can only be 20, 10, 8.
Address of the touch screen: master address, and sub address
For example, kinco servo drive manual on page 117, the address 2509, sub-address 06, median 20,
addressing the touch screen as shown:
- 140 -