Specifications

4 Communication settings and guide of HMI connecting with controller
Keyence KV-5000 EtherNet Slave protocol
HMI Setting
PLC configuration
1. "Editor" window, click [Configure unit] in the "[0] KV-5000 R30000" to modify the IP address of
the PLC, PLC and PC in the same segment, modify the IP address of the test shown, click [confirm] to save
the modifications
2. Switch to the "Monitor" window to see the changes of the figure will pop up window, Click [PLC
transfer -> Monitor mode (T)], pop-up "transmission program [communication goals: KV-5000 path:
USB]", Click [implementation], content writing, once again view the "[0] KV-5000 R30000" in the PLC's
IP address in the "Monitor" window [unit configuration], This indicates that the address has been modified
over.
◎Supported Device
KV-16DT
Device Bit Address Word Address Format
Counter Relay Counter_contact0- 59915
------ DDDDD
Timer Relay
Timer_contact0- 65535
------ DDDDD
High speed counter
CTH_contact0- 511
------
DDD
High speed counter Comparator
CTC_contact0- 511
------
DDD
Relay
Relay0- 32766
------
DDDDD
Counter current
------
Counter_current0- 3915
DDDD
Counter preset
------
Counter_preset0- 65535
DDDDD
Timer current
------
Timer_current0- 65534
DDDDD
Timer preset
------
Timer_preset0- 11998
DDDDD
- 146 -