Specifications

4 Communication settings and guide of HMI connecting with controller
4 7 even 1
5 7 even 2
◎Supported Device
Device Bit Address Word Address Format Notes
Alarm 1 status AA: 0 ------ D Read only
Burnout
B1: 0
------
D
Read only
PID control/Autotuning G1: 0 ------ D R/W
Alarm 2 status
AB: 0
------
D
Read only
RUN/STOP transfer
SR: 0
------
D
R/W
Self-tuning G2:0 ------ D R/W
Measured value ------ M1: 0 D Read only
Current transfomer input1 ------ M2: 0 D Read only
Current transfomer input2 ------ M3: 0 D Read only
Error code
------
ER: 0
D
Read only
Set value(SV1) ------ S1: 0 D R/W
Alarm 1 setting ------ A1: 0 D R/W
Alarm 2 setting
------
A2: 0
D
R/W
Heater break alarm 1 setting ------ A3: 0 D R/W
Heater break alarm 2 setting ------ A4: 0 D R/W
Control loop break alarm ------ A5: 0 D R/W
Heat-side proportional band ------ P1: 0 D R/W
Integral time ------ I1: 0 D R/W
Derivative time ------ D1: 0 D R/W
Anti-reset windup
------
W1: 0
D
R/W
Cool-side proportional band ------ P2: 0 D R/W
Overlap/deadband
------
V1: 0
D
R/W
Heat-side proportioning cycle
------
T0: 0
D
R/W
Cool-side proportioning cycle ------ T1: 0 D R/W
PV bias ------ PB: 0 D R/W
Set data lock function ------ LK: 0 D R/W
◎Cable Diagram
RS485 Communication Cable
com0/com1
Controller
RS485 terminal
HMI terminal
9pin D-SUB female/male
1 RX-
6 RX+
5 GND
485-
485+
GND
CAN bus Communication Cable
- 279 -