Commissioning Instructions

Table Of Contents

Siemens Industry, Inc. Start-up Procedures 140-1345

Restricted 2015-11-09

Table of Contents

Before You Begin ............................................................................................................... 5

Verifying Power .................................................................................................................... 6

Verifying Slave Mode Application Number .......................................................................... 7

Setting Controller Address ................................................................................................... 7

Setting the Application ......................................................................................................... 7

Setting Display Units ............................................................................................................ 8

Testing the Operator Display Panel ..................................................................................... 8

Setting Duct Area ................................................................................................................. 8

Setting Airflow Sensing Input ............................................................................................... 9

Setting Flow Coefficients ..................................................................................................... 9

Automatic Calibration Option ............................................................................................... 9

Setting Blank Display ......................................................................................................... 10

Setting Display Weight ....................................................................................................... 10

Setting Display Resolution ................................................................................................. 10

Changing Exhaust Minimum .............................................................................................. 11

Changing Exhaust Maximum ............................................................................................. 11

Changing Face Velocity Setpoints and OCC Delay .......................................................... 12

Setting Hi and Low Warn Limits ........................................................................................ 12

Setting Hi and Low Alarm Limits ........................................................................................ 13

Setting Alarm Timer ........................................................................................................... 13

Setting Emergency Setpoint .............................................................................................. 13

Setting Emergency Timer .................................................................................................. 13

Setting Remote Purge ....................................................................................................... 13

Fume Hood Specific Sash Setup and Calibration ............................................................. 14

Single Vertical Sash (Setup and Calibration) ..................................................... 14

Dual Vertical Sash (Setup and Calibration) ........................................................ 16

Vertical Sash Setup and Calibration .................................................................. 18

Setting External Face Area Input ....................................................................................... 20

Setting Sash Area Alarms .................................................................................................. 21

(Optional) Setting Damper Control — Application 6741 .................................................... 21

Checkout of Damper — Application 6741 ......................................................................... 21

(Optional) Setting Airflow Input Type ................................................................................. 22

(Optional) Calibrating the DP Transmitter without an Autozero Module ........................... 22

(Optional) Calibrating with an Autozero Module ................................................................ 23

AVS FAILMODE ................................................................................................................ 23

Setting Airflow Control — Application 6742 ....................................................................... 23

Range of Airflow Control – Application 6742 ..................................................................... 24

Configuring Airflow Control - Application 6742 .................................................................. 24

Venturi Operational Modes ................................................................................. 24