Data Sheet for Product

Information in this document is based on specifications believed correct at the time of publication. The right is reserved to make changes as
design improvements are introduced. Product or company names mentioned herein may be the trademarks of their respective owners.
© 2014 Siemens Industry, Inc.
Siemens Industry, Inc.
Building Technologies Division
1000 Deerfield Parkway
Buffalo Grove, IL 60089-4513
USA
Your feedback is important to us. If you have
comments about this document, please send them
to [e-mail].
Document No. 149-499
Printed in the USA
Page 11 of 11
Control Components
Part Number
Description
Part Number
Description
Actuation
GNP191.1P GNP Fast Acting Lab Electronic
Actuator
546-00020 No. 3 Pneumatic Actuator for Labs
GDE161.1P Fail-in-Last Position, Modulation, 44 in-
lb electric actuator
545-113 AO-P 0-10V - Voltage to Pneumatic
Transducer, 0-10 Vdc input
GMA161.1P Fail-safe Spring Return Modulating 62
in-lb electric actuator
546-00090 High-Speed pulsed pneumatic Transducer
GMA131.1P Fail-safe Spring Return Floating, 62 in-lb
electric actuator
GDE131.1P Fail-in-Last Position, Floating, 44 in-lb
electric actuator
Controllers
570-801P BACnet Lab Controller Module,
Applications 6723/6729, Low-Speed
550-819B
BACnet OAM - Off Board Air Module
570-803P BACnet Lab Controller Module,
Applications 6721/6727, High-Speed
570-811P BACnet Pressurized Room Controller,
Application 6731, Low-Speed
570-00701
BACnet Fume Hood Controller Module,
Applications 6741/6742/6740
590-780 Differential Pressure Transmitter, 1” WC, 4-
20 mA, 0.4% accuracy
550-767E Lab Controller Module, Applications
2621/2627, High-Speed
550-818B OAM – Off-board Air Module used in LCM-
OAVS controllers
550-767F Lab Controller Module, Applications
2623/2629, Low-Speed
550-767H Pressurized Room Controller, Application
2631, Terminals with Low-Speed
546-00705 Variable Volume Fume Hood Controller 546-00750A Constant volume Fume Hood Controller
3. Choose R for the Mounting Side, and append the letter to the part number. (The R is required.)
4. Choose the Inlet size (the size of the duct), and append the 2-digit number to the part number.
Inlet Size
(in inches)
2-digit Number
Inlet Size
(in inches)
2-digit number
4
04
11
11 (12” casing, special orifice)
6
06
12
12
7
07
14
14
8
08
16
16
9
09
18
18
10
10
—
—
5. Choose the Casing Material and the Sensor, and append the letters to the part number:
Casing Material and Sensor Type
BA
Stainless steel casing with orifice sensor.
B1
Stainless steel casing with orifice sensor, factory-sealed, immersion tested to 15”wc(3.75kPa)
B2
Same as B1, plus 2-valve signal isolation
B3
Same as B1, plus signal HEPA filters with 2-valve isolation
B5
Same as B1, plus signal HEPA filters with 5-valve isolation, including DECON port
6. Select the End fitting, and append that letter to the part number: F = Flange (S = Slip available)
7. (Custom Options): T = Transformer (120/24 CL.2) and Disconnect Switch