Data Sheet for Product

Siemens Building Technologies, Inc.
Page 9 of 10
Ordering Information
Part numbers are created based on the selections you choose. There are no spaces or dashes in the
SAP part number.
NOTE: Not all combinations or configurations will yield a valid part number in SAP.
Sample Part Number: LGDI885R14ROBO
Model
Number
Control
Package
Number
Mounting
Side
Inlet
Size
(Duct)
Hot Duct
Location
General
Options
Lining
Construction
LGD
I885
R
14
R
O
B
O
Laboratory
Room Dual
Duct
Supply Air
Terminal
This
package
provides
Lab Room
Controller,
an Interface
Board, and
2 electronic
actuators.
The R is
required; it
indicates
that the
controller
package is
mounted
on the
right side.
The inlet
(or duct)
size is 14
inches.
Mounted
on the
right.
Required.
Fiber-
free
foam
Ultra-low leakage
0.05% at 1” w.c. 1% at 6” w.c.
To create an orderable part number that can be entered in SAP, complete the following steps:
1. Begin with the Model Number, LGD.
2. Select a Control Package number, and append it to the Model Number:
Control
Package
includes the following Control Components…
Actuator Part
Number(s)
Transducer Part
Number
Flow Transmitter
Part Number
Controller Part
Number
G000 — — — —
I885
GNP191.1P
GDE161.1P
— — 546-00362
J840 546-00020 (2 each) — — 546-00360
Control Components Legend
Part Number Description Part Number Description
546-00020
No. 3 Pneumatic Actuator for
Labs
GNP191.1P GNP Fast Acting Lab Electronic Actuator
5460-00360 Lab Controller with Pneumatic
actuation
546-00362 Lab Room Controller with
electric actuation
GDE161.1P Fail-in-Last Position, Modulation, 44 in-lb electric
actuator
3. Append R to the Control Package (for the Control Package enclosure mounting).
R = Right side. (The R is required.)
4. Choose the Inlet size (the size of the duct), and append the 2-digit number to the part number.