Installation Instructions

Document No. 546-00580
Installation Instructions
May 22, 2012
Information in this document is based on specifications believed correct at the time of publication. The right is reserved to make changes as
design improvements are introduced. Product or company names mentioned herein may be the trademarks of their respective owners.
© 2012 Siemens Industry, Inc.
Siemens Industry, Inc.
Building Technologies Division
1000 Deerfield Parkway
Buffalo Grove, IL 60089-4513
USA
Tel. 1 + 847-215-1000
Your feedback is important to us. If you have
comments about this document, please send them
to [e-mail].
Document No. 546-00580
Printed in the USA
Page
7
of 7
GNP191 Actuation — Pulsed Control
1. Connect the Fast Acting Lab Electronic Actuator to
a source of 24 Vac power.
2. Connect the wire from the Fast Acting Lab
Electronic Actuator to the controller.
Switch Settings for the Fast Acting Lab Electronic
Actuator.
CAUTION
This actuator requires a maximum
of 20 VA, 24 Vac source.
DO NOT connect any other non-
isolated devices to the transformer
that powers the electronic actuator
or the hot water valve actuator.
NOTE:
See the Open Air® GNP/GAP Fail-
Safe/Fail-in-Place 53 lb-in (6 Nm),
Rotary, Electronic Damper Actuators
Technical Instructions (155-771)
for
more details.