Environmental Declaration

EPD - Type II
Based on ISO 14021
Brass, Stainless steel; nickel plated 15 - Swivel 0 … 3g
Cu 16 - Copper sensor wire clip 0 … 1g
Zn / Zn alloy 17 - Solder 0 … 1g
Brass 18 - Brass rivets 0 … 3g
Steel 19 - housing Screw 0 … 1g
Brass 22- Pulley wire clip 0 … 1g
Stainless Steel 23- Sensor nut 0 … 2g
Stainless steel, brass, PA66-F 20- Megatron Sensor 0 … 21g
PVC and Cu 21 - PVC Cable 0 … 100g
cellulose nitrate and alkyd resin 24- Green thread sealant 0 … 1g
SKF-LGLT 25 - Pulley grease 0 … 1g
*Variant parts list
[g]
3 - Upper Housing
4 - Lower Housing
5 - Heat Shrink wrapping
6 - Plastic Tie wrap
7 - Warning Tag
8 - Warning tag plastic tie
9 - Rubber Stopper
10 - Pulley
11- Pulley set screw
12 - Pulley end screw
Others
13 - Spring
14 -Sensor wire
15 - Swivel
16 - Copper sensor wire clip
17 - Solder
18 - Brass rivets
19 - housing Screw
22- Pulley wire clip
23- Sensor nut
20- Megatron Sensor
21 - PVC Cable
24- Green thread sealant
25 - Pulley grease
Packaging
1- Shipping Box [g]
2- Shipping Plastic wrap
Comments
EU-directive 2011/65/EU (RoHS)
The device does not contain substances in concentrations and applications banned under the EU RoHS Directive.
The device is classified as waste electronic equipment in terms of the European Directive 2012/19/EU (WEEE) and must
not be disposed of as unsorted municipal waste. Regarding disposal, use the systems setup for collecting electronic
waste.
Observe all local and applicable laws.
Disposal
The following applications which are exempted from the requirements of RoHS are used: 6c-Copper alloy containing up to 4% lead by weight
Restricted Page 2/3