Installation Instructions

Document No. 537-760

Rev. 3, February, 2000

Fume Hood Controller

Operator Display Panel (ODP)

Page 1 of 3

Product Description

The Fume Hood Controller Operator Display Panel

(ODP) (Figure 1) is the interface between the fume

hood operator and the controller system. The

mounting plate is designed for the fume hoods with

or without existing cutouts.

Product Number

537-720

Required Tools

For fume hood with an existing cutout you need:

• Medium flat-blade screwdriver

• Hex head wrench

For fume hood without a cutout you need:

• Medium duty electric drill

• 1-1/2 inch (38mm) hole saw bit

• Medium flat-blade screwdriver

• Hex head thermostat key

Prerequisites

• Cable from controller to ODP is in place.

• Cable from controller to ODP is less then 50 feet

(15m) in length.

Expected Installation Time

15 minutes

Instructions

NOTE:

The ODP must be mounted so that the

fume hood operator can easily read its

display and can easily reach its buttons

(Figure 1).

Figure 1. Operator Display Panel.

1. Choose the mounting location for the ODP. The

panel can be mounted directly on the fume hood

or on a nearby wall and can be mounted over a

pre-existing cutout on the fume hood.

2. Continue with one of the following two methods:

Installation with a Existing Cutout

Installation

without an Existing Cutout

PAGE 1
Installation Instructions Document No. 537-760 Rev. 3, February, 2000 Fume Hood Controller Operator Display Panel (ODP) Product Description The Fume Hood Controller Operator Display Panel (ODP) (Figure 1) is the interface between the fume hood operator and the controller system. The mounting plate is designed for the fume hoods with or without existing cutouts. Instructions NOTE: The ODP must be mounted so that the fume hood operator can easily read its display and can easily reach its buttons (Figure 1).
PAGE 2
Document No. 537-760 Installation Instructions Rev. 3, February, 2000 Installation with an Existing Cutout a. Position the mounting bracket over the existing cutout on the fume hood. Align the holes on the mounting bracket with the screw holes of the cutout (Figure 2). Installation without an Existing Cutout a. Using the mounting plate as a template, mark the location for the two-center mounting holes (Figure 4). Figure 4. Installation without Existing Cutout. Figure 2.
PAGE 3
Document No. 537-760 Installation Instructions Rev. 3, February, 2000 5. Place the ODP onto the mounting bracket so that the flange engages into the slot located inside the top of the panel housing (Figure 5). Figure 6. Placement of Information Label. The installation is complete. Figure 5. Placement of Panel on Mounting Plate. 6. Insert hex screw into the bottom tab of the mounting plate to secure the bottom of the ODP (Figure 5). 7.