Installation Instructions

Installation Instructions
Document No. 546-14402
December 8, 2011
CE Compliant Fume Hood Controller
Board
Item No. 546-14402. Rev. CA Page 1 of 6
Figure 1. CE Compliant Fume Hood Controller Board
(Standard enclosure).
Figure 2. CE Compliant Fume Hood Controller Board
(Other enclosure).
Product Description
The Fume Hood Controller Board (Figure 1 and
Figure 2) is the main termination board for the Fume
Hood Controller. The board comes with a ferrite filter
to suppress electrical emissions from the 8-conductor
cable. The ferrite filter must be installed to meet FCC
requirements and CE compliance.
Product Numbers
546-00701 CE Compliant Fume Hood Controller
Board with cover and mounting rail
546-00701E CE Compliant Fume Hood Controller
Board with FHC enclosure.
(Applications 900, 903, 905 and 907 with ferrite
filter).
NOTE: Keep the controller board in its static proof
bag until you are ready to install it on the
mounting posts.
Warning/Caution Notations
CAUTION:
Equipment damage, or loss
of data may occur if you do
not follow the procedures
as specified.
Expected Installation Times
23 minutes.
Required Tools and Materials
• Smallflat-blade screwdriver
Prerequisites
• Fume Hood Controller Enclosure is mounted
and wiring has been roughed-in.
• Operator Display Panel is installed and
cable pulled to location of controller.
Instructions
1. If the Fume Hood Controller will be used with a
field panel, then disconnect the Floor Level
Network (FLN) trunk from the field panel.
2. Place the ESD wrist strap on your wrist and
attach it to a good earth ground.