Operating Instructions and Installation Instructions

en Operating the appliance
6
Control panel model 2
Setting the fan
Switching on
■ Touch the # symbol.
The fan starts at setting ƒ.
■ Slide your finger across the III settings range to
change the fan speed.
Switching off
Touch the # symbol.
Intensive setting
You can use the intensive setting if there is a large
build-up of odours and fumes/vapours.
Slide your finger to the right across the III settings
range. Intensive settings ‚ 2 and ƒ2 can be selected.
After approximately six minutes, the electronics
automatically reduce the fan to a lower setting . If you
want to end the intensive setting before the preset time
expires, slide your finger to the left across the III
settings range until the required fan setting is reached.
Boost function
The boost function is a short-term maximum power
setting which can be activated at any fan setting.
Touch the & symbol. After approximately 20 seconds,
the fan switches back to the previously set fan setting.
Automatic mode
Switching on
■ Touch the # symbol.
The fan starts at setting ƒ.
■ Touch the ! symbol.
The optimum fan setting ‚, ƒ or „ is automatically
set via a sensor.
Switching off
Touch the ! or # symbol to switch automatic mode
off.
The fan switches off automatically if the sensor no
longer detects a change in the air quality of the room.
Automatic mode can run for a maximum of 4 hours.
Sensor control
In automatic mode, a sensor in the extractor hood
detects the intensity of the cooking and roasting
odours. Depending on the sensor setting, the fan
automatically switches to another fan setting.
Default sensitivity setting: „
Lowest sensitivity setting: ‚
Highest sensitivity setting: †
If the sensor control responds too quickly or too slowly,
it can be changed accordingly:
1. When the fan is switched off, hold the ! symbol
for approximately four seconds. The setting is
displayed.
2. The sensor control setting can be changed by
sliding your finger to the right or to the left across the
||| settings range.
3. To confirm the entry, hold the ! symbol for
approximately four seconds.
Lighting
The lighting can be switched on and off independently
of the fan.
Touch the = symbol.
Setting the brightness
Press and hold the = symbol until the desired
brightness is reached.
LQW
DXWR
Explanation
#
Fan on/off
=
Light on/off/dimming
&
Boost function (short-term maximum power)
!
Automatic mode with fan run-on
-|||+ Range of fan settings