Operation Manual

The most effective method of removing
vapours produced during cooking is to:
Switch the ventilator ON
as soon as you begin cooking.
Switch the ventilator OFF
a few minutes after you have finished
cooking.
Acoustic signal:
When a button is pressed, this is verified by
an acoustic signal.
Switching off the acoustic signal:
Simultaneously press buttons 0 and + until
a signal is emitted after approx. 3 seconds.
Switching on the acoustic signal:
Repeat the process.
Switching the fan ON
Press the + button
Setting the required fan speed:
Press the + button. The fan speed is
increased by one step.
Press the – button.
The fan speed is reduced by one step.
Switching the fan OFF:
Press the 0 button.The displayed 0 goes
out shortly afterwards.
Or:
Keep pressing the – button until the fan
switches off.
The displayed 0 goes out shortly afterwards.
Intensive setting:
Maximum power is obtained at the intensi-
ve setting. It is only required for short
intervals.
Keep pressing the + button until a P appears
in the display.
If the intensive setting is not cancelled by
hand, the fan will automatically switch back
to step 2 after 10 minutes.
Fan follow-on:
Press the
I
button.
The fan runs for 10 minutes at setting 1.
At the same time the
I
display comes on.
Then the fan switches off automatically.
Lighting:
Briefly press the button to switch the light
on and off.
The light can be switched on at any time,
even though the fan is switched off.
Adjusting the brightness: Hold down the
button until the desired brightness is
obtained.
Switching on the light automatically, e.g.
via a timer:
Fan and light must be switched off.
Switching on:
Simultaneously press the – and
I
buttons.
After approx. 3 seconds the light switches
on to acknowledge the setting.
Switching off:
Repeat the process with the light switched
on.
After approx. 3 seconds the light
switches off to acknowledge the setting.
Operating procedure
en