Service manual

3
86 Siemens-Elema AB E382 E380E 061 01 03 01
Disassembling and assembling Servo Ventilator 300/300A
Disassembling the panel
section
Front panel controls
• Separate the panel section from the
control section as previously described.
• Remove the knob cover (1).
• Remove the pin (2) if the control has a
push-button release function.
• Loosen the nut (3) holding the knob and
lift off the knob from the control shaft.
Use the knob holder tool, Order No.
62 04 197 E380E, when removing the
control knob.
• Disconnect the connector (4).
• Remove the two screws (5) and lift off the
control.
3
4
5
2
1
300-A27X
Separating the panel section
from the control section
• Remove the four screws (1).
• Carefully lift off the panel section (2).
The panel section is now separated from
the control section (3).
3
2
1
1
300-A26X