Manualshelf

Installation Instructions

ManualsBrandsSiemens Manuals3rd party integrationSystem Integratiion, American Auto-Matrix PUP Driver Technical Specification Sheet
12
Installation Instructions
Document No. 565-205
November 30, 2009
American Auto-Matrix PUP Driver
These install
ation instructions only cover the
connection o
f the American Auto-Matrix PUP Driver
to the Americ
an Auto-Matrix system. For hardware
installatio
n of the Modular Equipment Controller, see
document num
ber 565-570.
Product Des
cription
The American Auto-Matrix PUP Driver enables
communication between the APOGEE
®
Automation
System and the American Auto-Matrix devices.
This is done by removing the American Auto-Matrix
SAGE panel and replacing it with the American
Auto-Matrix PUP Driver, allowing the driver to control
the American Auto-Matrix PUP devices.
Product Numbers
986-88310G
American Auto-Matrix PUP
Driver, MEC with Ethernet
ALN, 8DI, 8DO, 8AI, 8AO,
Point Expansion Support,
HOA-ready
Warning
/Caution Notations
WARNING:
Persona
l injury/loss of life may occur if you
do not fo
llow the procedures as specif ed.
CAUTION:
Equipment damage or loss of data may
occur if you do not follow the procedures
as specif ed.
Expected Installation Times
20 minutes.
Required Tools and Materials
•Flat-
blade screwdriver (1/8-inch blade width).
• Wire stripper
s.
• Cabling and connectors. See the Connecting
the American Auto-Matrix PUP Driver to the
American Auto-Matrix Device section.
CAUTION:
Always wear an electro-static discharge
wrist strap and discharge accumulated
static before touching f eld panel
components.
Prerequisi
tes
• Driver hardware is installed according to its
respective installation instructions.
• FLN Termination blocks installed, if any.
Depending on the type of installation, other
prerequisites may have to be completed.
Communication with the American
Auto-Matrix PUP devices can be unstable
if there are multiple American Auto-Matrix
PUP devices powered from the same
power supply and if the wires are not
connected to the power terminals using the
same polarity. Even though the American
Auto-Matrix PUP devices use AC power,
the same power wire must be connected to
the AC Common terminal on all American
Auto-Matrix PUP devices. If the AC
power wires are crossed, the American
Auto-Matrix PUP device will run, but may
be unable to communicate with the driver.
Connecting the American
Auto-M
atrix PUP Driver to the
American Auto-Matrix Device
Follow
these steps to connect the American
Auto-
Matrix PUP Driver to the American Auto-Matrix
devic
e:
I
tem Number: 565-205, Rev. BA
P
age 1 of 2

Summary of content (2 pages)