Installation Instructions
Document No. 565-717T
Installation Instructions
July 31, 200 9
Connecting the Barber-Colman
Network 8000 Driver to the
Barber-Colman System
Follow these steps to connect the Barber-Colman
Network 8000 Driver to the Barber-Colman devices:
1. Make cables per diagram in Figure 1.
2. Connect cables per diagram in Figure 1.
LCM block functionality and LCM bus
integration are not supported with the
Barber-Colman Network 8000 Driver.
FLN
DRIVER
+
-
S
-
+
BARBER-COLMAN
DEVICES
MicroZone II (MZ II)
MicroFlo II (MF II)
Package Equipment Module (PEM)
MicroNet Integrator (ASDI)
TAPE BACK
SHIELD
GW1341R1
RS-485 TRUNK CABLE
(MAX 4000’/1200 m;
STANDARD 24 AWG LOW CAPACITANCE)
ASD Bus
Figure 1. Connecting the Barber-Colman Network 8000 Driver to the Barber-Colman System.
Information in this document is based on specifications believed correct at the time of publication. The right is reserved to make changes as
design improveme nts are introduced. Product or com pany names mentioned herein may be the trademarks of their respective owners.
© 2009 Siemens Building Technologies, Inc.
Siemens Building Technologies, Inc. Your feedb ack is important to us. If you have Document No. 565-717T
1000 Deerfield Parkway comments about this docu ment, send th em to Country of O rigin: U S
Buffalo Grove, IL 60089-4513 SBT_technical.editor.us.sbt@siemens.com.
Page 2 of 2
U.S.A.