Installation Instructions

Installation Instructions
Document No. 565-1003
March 7, 2011
EST3 Driver for PXC Modular
Item Number 565-1003AA) Page 1 of 3
These installation instructions cover the connection of
the EST Driver to the EST system only. For hardware
installation of the PXC Modular, see the PXC
Modular
Series Installation Instructions
(553-638).
Product Description
The EST 3 Driver enables communication between
the APOGEE® Automation System and the EST
system.
NOTE:
The ALN and/or FLN supports the EST
protocol once the controller is upgraded
to an Integration driver.
Product Numbers
PXC00-PE96.A PXC Modular, Ethernet or RS-485
ALN, 96 FLN nodes
PXC100-PE96.A PXC Modular, Ethernet or RS-485
ALN, 96 FLN nodes, TX-I/O support
PXX-485.3 Expansion Module, three RS-485 FLN
connections
LSM-INT-EST3 License for EST 3 PXC Modular Driver
Accessories
538-670 Trunk Interface II, 115V
538-675 Trunk Interface II, 230V
Caution Notation
CAUTION
Equipment damage or loss of data may
occur if you do not follow a procedure as
specified.
Expected Installation Time
30 minutes
Required Tools and Materials
 Flat-blade screwdriver (1/8-inch blade width).
 Wire strippers.
 Cabling and connectors. See the Connecting the
EST3
Driver to the EST3 System section.
CAUTION
Always wear an electro-static discharge
(ESD) wrist strap and discharge
accumulated static before touching field
panel components.
Prerequisites
 Driver hardware is installed according to its
respective installation instructions.
 One 115V or 230V receptacle (depending on
device) to power the Trunk Interface II.
 Ethernet infrastructure is installed.
Depending on the type of installation, other
prerequisites may have to be completed.