Installation Instructions

Installation Instructions
Document No. 565-712T
November 12, 2013
Johnson Controls N2 Master Driver for TC Modular and TC-36
Item Number 565-712T(CA)
Page 1 of 2
These installation instructions cover the connection of
the Johnson Controls N2 Master Driver to the
Johnson Controls N2 Master system only.
 For hardware installation of the TC Modular, see
the
TC Modular Series Installation Instructions
(553-654).
 For hardware installation of the TC-36, see the
TC Compact 36 Installation Instructions (553-
680).
Product Description
The Johnson Controls N2 Master Driver enables
communication between the TALON® Automation
System and Johnson Controls devices. This is done
by removing the Johnson Controls Field Panel and
replacing it with the Johnson Controls N2 Master
Driver, allowing the driver to control the Johnson
Controls N2 trunk.
Product Numbers
License
LSM-INT-JCIN2M.T
License to enable the Johnson
Controls N2 Master Driver on TC
Modular or TC-36 hardware.
TC Modular Series
TC1000-E96.T
TC Modular, BACnet/IP or MS/TP
ALN, 96 FLN nodes
PXX-485.3
Expansion Module, three RS-485 FLN
connections (For TC-Modular only.)
TC Compact Series
TC36-E.T
TC Compact, 36 point, BACnet/IP or
MS/TP ALN
Caution Notation
CAUTION
Equipment damage or loss of data may
occur if you do not follow a procedure as
specified.
Expected Installation Time
30 minutes
Required Tools and Materials
 Flat-blade screwdriver (1/8-inch blade width).
 Wire strippers.
 Cabling and connectors. See the
Connecting the
Johnson Controls N2 Master Driver to the
Johnson Controls N2 Trunk
section.
CAUTION
Always wear an electro-static discharge
(ESD) wrist strap and discharge
accumulated static before touching field
panel components.
Prerequisites
 Driver hardware is installed according to its
respective installation instructions.
 FLN Termination blocks installed, if any.
Depending on the type of installation, other
prerequisites may have to be completed.