Printer Accessories User Manual

Multi Address Appearance on OpenStage 00.00.2007 I 15
User Configuration Items
The user can configure the phone behaviour relating to a line and the corresponding overview accord-
ing to his personal needs.
Line Configuration Menu
The menu can be accessed using the Web Based Management (WBM) or the local user menu at the
phone. The location is:
User > Configuration > Keyset > Lines
WPI (see [4]) tags are available for these settings, too.
User Line Key Configuration
The keyset line configuration can be
done separately for each individual
line. Each line has a tab of its own in
which the parameters are set.
Parameter Meaning
Ring delay
(seconds)
Number of seconds until the phone will play the ringing tone for an incoming call.
Allow in
overview
If checked, the line will be shown in the overview table.
Address AoR resp. call number for this line (not configurable by the user).
Primary line Line status (not configurable by the user).
Ring on/off If checked, a ringer tone is played for incoming calls on this line (not configurable
by the user).
Selection order Used for outgoing calls if idle lines are selected automatically (not configurable by
the user).
Hot/warm line Not used in this context.
Hot/warm
destination
Not used in this context.