Specifications

Migration from MC35 to MC35i
RELEASED
MC35_MC35i_MIG_V01.03 Page 19 of 33 23.04.03
3.9 Mechanical dimensions
MC35 and MC35i provide the same type of connectors and mounting holes on the board.
The position of mounting holes is identical as with MC35, as well as the order of external
connectors. The outline mechanical dimensions are identical with both devices except the
height. MC35i is a single side mounted device and is therefore thinner than MC35. Please
note that all test points must be electrically isolated to ensure ESD protection
The heat sink shown in Figure 2 should not cover the marked test points. For further
information refer to [3].
0,00 = Reference point All dimensions in millimeter
Figure 1: Mechanical dimensions of MC35
Not connected
BATT+ pad
Identification label
GroundGround Ground
Place for
heatsink
Ground
GND pad
All dimensions in millimeter
Figure 2: Mechanical dimensions of MC35i