Specifications

MC35i AT Command Set
18.2 ATS3
s
m obil e
MC35i_ATC_V01.03 Page 417 of 444 5/7/04
Confidential / Released
18.2 ATS3 Write command line termination character
The ATS3 command determines the character recognized by the TA to terminate an incoming command line.
Syntax
Parameter Description
command line termination character
000...13
(&F)
...127
Notes
• Using a value other than the default 13 may cause problems when entering commands.
• Whenever you change the setting take into account that the new value has no effect on the URC "
^SHUT-
DOWN
".
Read Command
ATS3?
Response(s)
<n>
OK
Write Command
ATS3=<n>
Response(s)
OK
ERROR
PIN ASC0 MUX1 MUX2 MUX3
! % % % %
Reference(s)
V.25ter
<n>
(num)(&W)(&V)