User Manual

P/N 315-092626-4

Installation Instructions

Model MHD-2W

Dead Front Panel

Siemens Industry, Inc.

Building Technologies Division

Florham Park, NJ

Siemens Canada Limited

Building Technologies Division

2 Kenview Boulevard

Brampton, Ontario L6T 5E4 Canada

to the DV-100 Wiring Diagram (P/N 315-

192756/7) for information on wiring the

DC-35S.

2. Mount the MHD-2W panel on the right-

hand side of the MBR-2 backbox in the

bottom enclosure position using the bottom

three mounting holes. Refer to the MHD

Installation Instructions, P/N 315-092101,

for additional information on mounting the

panels.

The Model MHD-2W is a dead-front panel

that is used in place of an MHD-2 panel

when an external DV-100 is used. The

MHD-2W is used in the MBR-2 enclosure of

the MXL/MXLV System so that a DC-35S

can be mounted on the inside of the panel.

MOUNTING

1. Mount the DC-35S in the four studs on

the rear of the MHD-2W using the four

screws provided (See Figure 1). Refer

Figure 1

Mounting the DC-35S on the back of the MHD-2W

PAGE 1
Installation Instructions Model MHD-2W Dead Front Panel The Model MHD-2W is a dead-front panel that is used in place of an MHD-2 panel when an external DV-100 is used. The MHD-2W is used in the MBR-2 enclosure of the MXL/MXLV System so that a DC-35S can be mounted on the inside of the panel. MOUNTING 1. Mount the DC-35S in the four studs on the rear of the MHD-2W using the four screws provided (See Figure 1). Refer to the DV-100 Wiring Diagram (P/N 315192756/7) for information on wiring the DC-35S. 2.