User Manual

SINAMICS G120 CU230P-2 Control Units

List Manual (LH9), 04/2014, A5E33838102B AA

437

2 Parameters

2.2 List of parameters

Description: Sets the signal source of input quantities X0 and X1 of instance NSW 1 of the numeric changeover switch.

Index: [0] = Input X0

[1] = Input X1

Description: Sets the signal source of the switch setting I of instance NSW 1 of the numeric changeover switch.

Description: Display parameter for output quantity Y of instance NSW 1 of the numeric changeover switch.

Description: Setting parameter for the run-time group in which the instance NSW 1 of the numeric changeover switch is to be

called.

Value: 5: Run-time group 5

6: Run-time group 6

9999: Do not calculate

Description: Setting parameter for the run sequence of instance NSW 1 within the run-time group set in p20226.

Note: The function blocks with a lower run sequence value are calculated before function blocks with a higher run

sequence value.

p20223[0...1] CI: NSW 1 inputs / NSW 1 inputs

Access level: 3 Calculated: - Data type: U32 / FloatingPoint32

Can be changed: T Scaling: PERCENT Dyn. index: -