User Manual

ManualsBrandsSiemens ManualsVariable Speed DriveSINAMICS G120 Control Units CU230P-2 Parameter Manual

Parameters

List of parameters

1-36

SINAMICS G120 CU230P-2 Control Units List Manual (LH9), 01/2013

Note: The following status bits are displayed in r0053:

Bit 00: r1239 Bit 8

Bit 01: r2197 Bit 5 (negated)

Bit 02: r2197 Bit 0 (negated)

Bit 03: r2197 Bit 8

Bit 04: r2197 Bit 2

Bit 05: r2197 Bit 1

Bit 06: r2197 Bit 4

Bit 07: r2197 Bit 9

Bit 08: r2197 Bit 10

Bit 09: r1199 Bit 2 (negated)

Bit 10: r2349 Bit 10

Bit 11: r2349 Bit 11

Description: Displays control word 1.

Note: The following control bits are displayed in r0054:

Bit 00: r0898 Bit 0

Bit 01: r0898 Bit 1

Bit 02: r0898 Bit 2

Bit 03: r0898 Bit 3

Bit 04: r0898 Bit 4

Bit 05: r0898 Bit 5

Bit 06: r0898 Bit 6

Bit 07: r2138 Bit 7

Bit 08: r0898 Bit 8

Bit 09: r0898 Bit 9

Bit 10: r0898 Bit 10

Bit 11: r1198 Bit 11

Bit 13: r1198 Bit 13

Bit 14: r1198 Bit 14

Bit 15: r0836 Bit 0

r0054.0...15 CO/BO: Control word 1 / STW 1

Access level: 2 Calculated: - Data type: Unsigned16

Can be changed: - Scaling: - Dyn. index: -

Units group: - Unit selection: - Func. diagram: -

Min Max Factory setting

- - -

Bit field: Bit Signal name 1 signal 0 signal FP

00 ON/OFF1 Yes No -

01 OC / OFF2 Yes No -

02 OC / OFF3 Yes No -

03 Operation enable Yes No -

04 Ramp-function generator enable Yes No -

05 Continue ramp-function generator Yes No -

06 Speed setpoint enable Yes No -

07 Acknowledge fault Yes No -

08 Jog bit 0 Yes No 3030

09 Jog bit 1 Yes No 3030

10 Master ctrl by PLC Yes No -

11 Direction reversal (setpoint) Yes No -

13 Motorized potentiometer raise Yes No -

14 Motorized potentiometer lower Yes No -

15 CDS bit 0 Yes No -