User Manual

List of parameters

Parameters

1-433

SINAMICS G120 CU230P-2 Control Units List Manual (LH9), 01/2013

Description: Setting parameter for the run sequence of instance BSW 1 within the run-time group set in p20216.

Note: The function blocks with a lower run sequence value are calculated before function blocks with a higher run

sequence value.

Description: Sets the signal source of input quantities X0 and X1 of instance NSW 0 of the numeric changeover switch.

Index: [0] = Input X0

[1] = Input X1

Description: Sets the signal source of the switch setting I of instance NSW 0 of the numeric changeover switch.

Description: Display parameter for output quantity Y of instance NSW 0 of the numeric changeover switch.

Description: Setting parameter for the run-time group in which the instance NSW 0 of the numeric changeover switch is to be

called.

Value: 5: Run-time group 5

6: Run-time group 6

9999: Do not calculate

p20217 BSW 1 run sequence / BSW 1 RunSeq

Access level: 3 Calculated: - Data type: Unsigned16

Can be changed: T Scaling: - Dyn. index: -