User Manual

Parameters

Command and drive data sets - overview

1-472

SINAMICS G120 CU230P-2 Control Units List Manual (LH9), 01/2013

p2930[0...n] CO: Fixed value M [Nm] / Fixed value M [Nm]

p3231[0...n] Load monitoring speed deviation / Load monit n_dev

p3233[0...n] Torque actual value filter time constant / M_act_filt T

p3320[0...n] Fluid flow machine power point 1 / Fluid_mach P1

p3321[0...n] Fluid flow machine speed point 1 / Fluid_mach n1

p3322[0...n] Fluid flow machine power point 2 / Fluid_mach P2

p3323[0...n] Fluid flow machine speed point 2 / Fluid_mach n2

p3324[0...n] Fluid flow machine power point 3 / Fluid_mach P3

p3325[0...n] Fluid flow machine speed point 3 / Fluid_mach n3

p3326[0...n] Fluid flow machine power point 4 / Fluid_mach P4

p3327[0...n] Fluid flow machine speed point 4 / Fluid_mach n4

p3328[0...n] Fluid flow machine power point 5 / Fluid_mach P5

p3329[0...n] Fluid flow machine speed point 5 / Fluid_mach n5

p3856[0...n] Compound braking current / Compound I_brake

r3925[0...n] Identification final display / Ident final_disp

r3927[0...n] Motor data identification control word / MotID STW

r3928[0...n] Rotating measurement configuration / Rot meas config

r3929[0...n] Motor data identification modulated voltage generation / MotID U_gen mod