User Manual
Table Of Contents
- PM230 Power Module, IP55
- Legal information - Warning notice system
- Table of contents
- 1 Changes in this manual
- 2 Fundamental safety instructions
- 3 Launch
- 4 Installing/mounting
- 5 Connecting
- 6 Service and maintenance
- 7 Technical data
- 7.1 Overload capability of the inverter
- 7.2 Cable cross-sections and tightening torques
- 7.3 Electromagnetic compatibility - Overview
- 7.4 Ambient conditions
- 7.5 General technical data
- 7.6 Specific technical data
- 7.7 Restrictions for special ambient conditions
- 7.8 Current reduction depending on pulse frequency
- 7.9 Electromagnetic compatibility of variable-speed drives
- 8 Spare parts and accessories
- A Appendix
- Index
Launch
3.1 Component specification according to UL
PM230 Power Module, IP55
18 Hardware Installation Manual, 12/2016, A5E35319202B AB
STO with PM230 and CU240
The PM230 FSA … FSC Power Modules have been technically revised. Together with
CU240 Control Units, software version 4.7 SP3 and higher, they support the STO safety
function.
You can identify the new series of Power Modules from the article number. The article
numbers of the new Power Modules have a "G" instead of an "A" in the last but one position.
Otherwise, the article numbers are identical.
3.1
Component specification according to UL
The FSA ... FSC inverters are UL approved acc. to UL508C and CSA C22.2 No.274-13.
The FSD ... FSF inverters are TÜV approved acc. to UL508C.
Further information and a link for downloading the appropriate certificates can be found in
the following Section:
Directives and standards (Page 70)
3.2
Permissible motors
Note
Motors for inverter operation
Only use motors that are suita
ble for operation with inverters with a DC link.
Permissible motors
For the Power Modules, induction motors are permissible in the range from 25 % … 150 %
of the inverter power without any restrictions.