User Manual
Table Of Contents
- PM230 Power Module, IP55
- Legal information - Warning notice system
- Table of contents
- 1 Changes in this manual
- 2 Fundamental safety instructions
- 3 Launch
- 4 Installing/mounting
- 5 Connecting
- 6 Service and maintenance
- 7 Technical data
- 7.1 Overload capability of the inverter
- 7.2 Cable cross-sections and tightening torques
- 7.3 Electromagnetic compatibility - Overview
- 7.4 Ambient conditions
- 7.5 General technical data
- 7.6 Specific technical data
- 7.7 Restrictions for special ambient conditions
- 7.8 Current reduction depending on pulse frequency
- 7.9 Electromagnetic compatibility of variable-speed drives
- 8 Spare parts and accessories
- A Appendix
- Index
Installing/mounting
4.4 Installing the Control Unit and Operator Panel
PM230 Power Module, IP55
26 Hardware Installation Manual, 12/2016, A5E35319202B AB
4.4
Installing the Control Unit and Operator Panel
4.4.1
Installing the Control Unit
Installing the Control Unit, PM230 IP55 - FSA … FSC
To insert or detach the Control
Unit, you must rel
ease eight or
ten fixing screws of the cover
and then remove the cover.
Insert the lugs on the rear panel
of the Control Unit into the a
p-
propriate recesses of the Power
Module. Snap in the Control Unit
as shown in the illustration.
To remove, loosen the Co
ntrol
Unit from the Power Module by
pressing the release lever.
Reinstall the cover before you
commission the inverter. Do not
damage the seal of the cover
when attaching it.
Using the operator panel with a CU230P-2 Control Unit
If you use an operator panel, connect the adapter provided to the Control Unit as shown in
the illustration.
Using the operator panel with a CU240B/E-2 Control Unit
With a CU240B/E-2, you will need an adapter from KnorrTec instead of the adapter
provided.
Accessories (Page 66)