User Manual
Table Of Contents
- PM230 Power Module, IP55
- Legal information - Warning notice system
- Table of contents
- 1 Changes in this manual
- 2 Fundamental safety instructions
- 3 Launch
- 4 Installing/mounting
- 5 Connecting
- 6 Service and maintenance
- 7 Technical data
- 7.1 Overload capability of the inverter
- 7.2 Cable cross-sections and tightening torques
- 7.3 Electromagnetic compatibility - Overview
- 7.4 Ambient conditions
- 7.5 General technical data
- 7.6 Specific technical data
- 7.7 Restrictions for special ambient conditions
- 7.8 Current reduction depending on pulse frequency
- 7.9 Electromagnetic compatibility of variable-speed drives
- 8 Spare parts and accessories
- A Appendix
- Index
Service and maintenance
6.1 Maintenance
PM230 Power Module, IP55
44 Hardware Installation Manual, 12/2016, A5E35319202B AB
Changing the internal fan FSA … FSC
No tools are required to change the fan.
Preparation
1. Switch off the inverter.
2. Wait at least 5 minutes until the Power Module has fully discharged.
3. Remove the front cover of the inverter.
Procedure
1. Remove the power plug of the fan ①.
2. Press the holding clips of the fan module downward
②.
3. Remove the fan module from the guide rail
③.
4. Insert the new fan module until the holding clip locks in with a click
④.
5. Insert the power plug of the fan module
⑤.
6. Re-attach the front cover of the inverter.
Now you have changed the fan.
6.1.2.2
Replacement of the fans for the frame sizes FSD ... FSF
Changing the external fan FSD … FSF
To change the fan, you will need a Torx screwdriver, size 20.
Preparation
1. Switch off the inverter.
2. Wait at least 5 minutes until the Power Module has fully discharged.