User Manual

Appendix
A.2 Directives and standards
PM230 Power Module, IP55
70 Hardware Installation Manual, 12/2016, A5E35319202B AB
A.2
Directives and standards
Relevant directives and standards
The following directives and standards are relevant for the inverters:
European Low Voltage Directive
The inverters fulfil the requirements stipulated in Low Voltage Directive 2014/35/EU insofar
as they are covered by the scope of application of this Directive.
European Machinery Directive
The inverters fulfil the requirements stipulated in Machinery Directive 2006/42//EU insofar as
they are covered by the scope of application of this Directive.
Use of the inverters in a typical machine application has been fully assessed for compliance
with the main regulations in this Directive concerning health and safety.
European EMC Directive
By completely complying with IEC/EN 61800-3, it has been proven that the inverter is in
compliance with Directive 2004/108/EC or 2014/30/EU.
Underwriters Laboratories (North American market)
Inverters bearing one of the certification marks shown on the left meet the requirements for
the North American market as a component of drive applications and are listed
correspondingly.
EMC requirements for South Korea
The inverters with the KC marking on the rating plate satisfy the EMC requirements for South
Korea.
Eurasian conformity
The inverters comply with the requirements of the Russia/Belarus/Kazakhstan customs
union (EAC).
Australia and New Zealand (RCM formerly C-Tick)
The inverters bearing the certification mark shown here meet the EMC requirements for
Australia and New Zealand.