User Manual
List of Parameters
Parameters
1-345
© Siemens AG 2011 All Rights Reserved
SINAMICS G120 Control Units CU230P-2 Parameter Manual (LH9), 06/2011
Description: Display and binector output for the output of timer 3 (DTC3).
Where a weekday is de-activated, the following applies (p8430):
- The binector output for this timer is inactive (r8433.0 = 0).
Where a weekday is activated, the following applies (p8430):
- The ON/OFF time setting (p8431, p8432) for this timer has an instant effect on the binector output (r8433).
Dependency: Refer to: p8409, p8430, p8431, p8432
Notice: This parameter can only be changed when p8409 = 0.
Note: DTC: Digital Time Clock (timer)
RTC: Real-time clock
Description: Displays the macro file saved in the appropriate directory on the memory card/device memory.
Dependency: Refer to: p0015
Note: For a value = 9999999, the following applies: The read operation is still running.
Description: Displays the ACX file saved in the appropriate directory in the non-volatile memory.
Dependency: Refer to: p0700
Note: For a value = 9999999, the following applies: The read operation is still running.
Description: Displays the ACX file saved in the appropriate directory in the non-volatile memory.
Dependency: Refer to: p1000
Note: For a value = 9999999, the following applies: The read operation is still running.
r8433.0...1 BO: RTC DTC3 output / RTC DTC3 output
Access level: 3 Calculated: - Data type: Unsigned16
Can be changed: - Scaling: - Data set: -
Units group: - Unit selection: -
Min Max Factory setting
- - -
Bit field: Bit Signal name 1 signal 0 signal FP
00 Timer on Yes No -
01 Timer ON negated No Yes -
r8570[0...39] Macro drive object / Macro DO
Access level: 1 Calculated: - Data type: Unsigned32
Can be changed: - Scaling: - Data set: -
Units group: - Unit selection: -
Min Max Factory setting
- - -
r8571[0...39] Macro Binector Input (BI) / Macro BI
Access level: 4 Calculated: - Data type: Unsigned32
Can be changed: - Scaling: - Data set: -
Units group: - Unit selection: -
Min Max Factory setting
- - -
r8572[0...39] Macro Connector Inputs (CI) for speed setpoints / Macro CI n_set
Access level: 4 Calculated: - Data type: Unsigned32
Can be changed: - Scaling: - Data set: -
Units group: - Unit selection: -
Min Max Factory setting
- - -