Specifications

5.2 Axis expansion with SIMODRIVE 611D control plug-in unit

5-81

SINUMERIK 810D Equipment Manual Configuration CCU (PHC) – 03/2006 Edition

Note

For EMC-compliant assembly, shielded motor cables must be used in

conjunction with the shielding contact plates available for SIMODRIVE power

modules; see

References: /PJU/, Configuration Manual Converters

/EMV/, EMC Configuring Guidelines

For connection of the SIMODRIVE 611D control plug-in unit that is located

immediately to the right of the 810D.

Drive bus cable

Device bus cable

54 105

Fig. 5-5 Cable set for axis expansion with SIMODRIVE 611D module

Table 5-2 Recommendation for length selection of the drive bus cable

Order no. Module width to be

bridged in mm

Comment

6SN1161-1CA00-0BA1 50 Drive bus cable round

cable, shielded

6FC5247-0AA28-0AA0 50 Device bus cable

GWE: 462008006403 50 Device bus cable

6SN1161-1AA00-0BA0 <50 Device bus cable 400 mm

NC60 Catalog: Select

length + 50 mm

<50 Drive bus cable round

cable, shielded



Cable set for axis

expansion

5 Axis Ex

ansion