User's Manual

Page 216 MultiRanger 100/200 – INSTRUCTION MANUAL 7ML19981FB06

mmmmm

Parameters

P902 Watchdog

Press ENTER to put the CPU into an infinite loop to test the watchdog timer.

On successful completion (10 seconds) the RUN mode is entered and the MultiRanger is

reset. Programming is kept and the unit responds as if there had been a power failure.

P903 Display

Press ENTER to activate the display test.

All LCD segments and symbols are temporarily displayed.

P904 Keypad

Press ENTER , then press each keypad key in the following sequence:

As each key is pressed, the associated keypad number is displayed. On successful test

completion, PAS S is displayed. FAIL is displayed if a key is pressed out of sequence or the

programmer keypad malfunctions.

P905 Transmit Pulse

Press ENTER to supply repeated transmit pulses, at the frequency entered, to the

transducer and / or view the transducer operating frequency (automatically altered by

P004 Transducer) for the Point Number displayed.

P906 RS-232 Port

Press ENTER

to test the RS-232 port on the RJ-11.

An external device must be connected to the RS-232 port for this test. On successful

completion, PAS S is displayed, otherwise it is FAIL.

Primary Index

Single Point Model Dual Point Model

Global Transducer

Values Range: 42kH to 46KH (view only)

Altered By • P004 Transducer