Operation Manual

Enhanced phone functions 103
Retrieving a held call
Press the corresponding line key. The line key LED lights up. The call is re-
trieved.
Held call wait status
After placing a call on hold, you can replace the handset and then decide wheth-
er to retrieve the call or disconnect.
Prerequisite: You placed a call on hold and replaced the handset or pressed
the loudspeaker key in speakerphone mode.
A recall follows immediately and a pop-up menu appears on the display:
Confirm with the softkey to retrieve the held call in speakerphone mode.
or
Confirm with the softkey to disconnect the held call.
The LED display  Page 25 or status display on the "Overview" tab
 Page 35 indicates to other multi-line telephones on which this line is
also configured that the call is on hold. These phones can then pick up the
call.
Reconnect
Disconnect
If you enabled "Hold and hang-up" ( Page 105), the call is placed on hold
for a defined time interval ( Page 104) before the prompt is displayed
with a recall to retrieve the call or disconnect. You can however retrieve the
call or disconnect via the softkeys "Reconnect" and "Disconnect" before
the defined time expires.
This function is not considered on multi-line phones.