System information

Polycom Unified Communications Deployment Guide for the OpenScape Solution of Siemens Enterprise Communciations
6–16 Polycom, Inc.
Ethernet Settings
For the RMX 1500/4000 platforms, you can manually modify the
automatically identified speed and transmit/receive mode of each LAN port
that the system uses if the specific switch requires it in the Ethernet Settings
dialog box. These settings are not part of the Management Network dialog box
as for RMX 2000.
RMX 1500: The Port numbers displayed in the dialog box do not reflect the
physical Port numbers as labeled on the RMX 1500 MCU.
The physical mapping of Port Type to the physical label on the back panel of
the RMX 1500 is shown in the following table.
To modify the automatic LAN port configuration:
1 On the RMX menu, click Setup > Ethernet Settings.
The Ethernet dialog box opens.
Note: On the RMX 1500, the Port numbers displayed in the dialog box do not
reflect the physical Port numbers as labeled on the RMX 1500 MCU.
Port Type Label on MCU
1500 4000
Media LAN 2 LAN 2 RTM LAN Card
Modem Modem LAN 1 RTM-IP 4000 Card
Management 1 MNG B LAN 2
Signaling 1 MNG LAN 3
ShM Shelf LAN 6
Note: On the RMX 1500/4000, although the RTM LAN (media card) port is shown
as Port 1 in the Ethernet Settings and Hardware Monitor fields, the physical LAN
connection is Port 2.