Quick Start Guide

Figure 6. Installation of Bay Option Modules

1. Disconnect the phone line from the wall jack or phone and

place the phone

➀

on a soft surface with the keypad facing

down.

2. Hold the adapter

➁

with the male connector strip facing

down and mount it in one of the two mounting locations on

the bottom of the phone, sliding the two tabs

➂

into the two

slots

➃

3. Gently press down on the adapter until the male connector

strip is inserted all the way into the female connector strip

➄

For the

Analog Adapter

, connect an analog device to the 6-pin

RJ11 port on the back of the Analog Adapter (connecting tip/

ring to pins 3 and 4). Reconnect the phone line to the phone.

Note that the analog adapter requires the Optiset E Local Power

Supply for operation.