User Manual

1/3

Building Technologies 08-05-905 E

Fire Safety & Security Products

Orifice plate ENGLISH

08-05-905

PED-category: SEP Index Description Date

Fluid group: 2 01.10.09

Product line

Sinorix ™

CX ref. no.

854005

SAP

S54476-B26-A1

Double nipple with filter

PN240

97/23/EG

Usage

H20 Gas 300

: 1-n water cylinders, if H2O orifice is drilled < 3.0mm

This part has to be used when the next part in flow direction has a drilling diameter smaller than 3.0mm.

It is installed with HP joints or HP hose. The part has a coaxial hole. The direction of flow is defined and stamped.

On the inlet side a filter is fixed.

Technical data

working pressure 240 bar

test pressure 360 bar

operating temperature range -20°C / +50°C

serial no week/year

material steel EN10027-2: grade 1.4305

orifice diameter range A 7.2 mm

inlet DKOS16

outlet G 1/2

weight 0.20 kg

Safety warning

This product information is exclusively intended for specialized operators with the experience in designing,

mounting, installing, commissioning, maintaining and retrofitting fire extinguishing systems. The user must ensure

that the part is not abused an only used within its design limits and that all danger to life and limb of the operator,

or third parties, is avoided. Moreover, compliance must be ensured with accident prevention regulations and

national regulations. The user must also ensure that all persons the equipment have read and understood these

product information.

direction of flow

PAGE 1
Orifice plate ENGLISH 08-05-905 PED-category: SEP Fluid group: 2 Product line Sinorix ™ CX ref. no. 854005 SAP S54476-B26-A1 Index Double nipple with filter PN240 Description Date 01.10.09 97/23/EG direction of flow Usage H20 Gas 300® : 1-n water cylinders, if H2O orifice is drilled < 3.0mm This part has to be used when the next part in flow direction has a drilling diameter smaller than 3.0mm. It is installed with HP joints or HP hose. The part has a coaxial hole.
PAGE 2
Installation instructions This part has to be used when the next part in flow direction has a drilling diameter smaller than 3.0mm. It is installed with HP joints or HP hose. The part has a coaxial hole. The direction of flow is defined and stamped. On the inlet side a filter is fixed. Requirements • • The part must be installed in the correct direction of flow. Fitting position is independent. Procedure 1. 2. 3. Assembly in accordance with detail X.
PAGE 3
Maintenance After an extinguishant discharge: • • Check that the part connection to the pipework is secure and the discharge hose connection to the orifice is tight. Disassembly of the unit group and control of filter, reserve filter (CX 851002 / S54476-B25-A3) Service inspection requirements: • • • Check the pipework for any unauthorized modifications which may result in a change of orifice diameter. Check the orifice for any damage or corrosion.