Configuration Instructions

Hardware specific configuration

Dig. matrix monitor (4/4/16)

A6V10429097_en--_e

139 | 219

7.1.1 'SpeakerLines'

'Line #'

Output line in the range 1…16.

'Name'

Free text for system overview.

'Rated Power'

The rated power of the configured line in watts [W].

'Active'

Enables a specific line.

'Amp'

Routes the line to a 100 V input in the range 1…4.

'Loop'

This speaker line is part of a loop. Configure a second speaker line to enable this

option.

'Priority Only'

If this flag is enabled, no program will be played on this line.

'Line Detection State'

Shows information about the electrical state of a speaker line.

7.1.2 'Amplifiers'

In the 'Amplifiers' area you can specify the connected amplifiers.

'Speaker Lines Rated Power'

Displays the sum of the power (consumption) of all speaker lines connected to this

amplifier.

'Installed Amplifier'

Configure the type of amplifier, connected to the analog audio output of the device.

For example, 'PV1001 1x200 – Channel A'.

'Installed Amplifier Power'

Depending on the installed amplifier, it will display the nominal power of the

amplifier.

'Current State'

See the fault state of a connected amplifier. 'ok' means the amplifier is operational.