Configuration Instructions

Hardware specific configuration
'Logic Inputs – Connector'
7
150 | 219
A6V10429097_en--_e
Function
Description
'EN 54-16: Alarm Manual
Silence'
Manual silencing of the voice alarm condition. (Option 7.6.2 in EN 54-16)
'GP' flag:
● If set, then on 'Starting': all zones are selected; on 'Stopping': all zones are
deselected
● If not set, then no additional action is taken
'EN 54-16: System Fault
Reset'
Manual reset of fault indications.
'GP' flag:
● If set, then just local use of information
● If not set, then: information over the network is distributed
'EN 54-16: Alarm Manual
Reset'
Manual reset of the voice alarm condition. (Option 7.7.2 in EN 54-16)
'Alarm Start/Stop'
Triggers a pre-recorded alarm call, stored on a SD card, from a target station.
A virtual or real button can be created to trigger the alarm file; this makes
operation easier. Positive edge of the input starts the file. A negative edge
stops the alarm file.
'Disablement Condition'
This feature is used to suppress the error messages of the 'LineDetection' card
for a specific speaker line. The supplied parameters 1...16 are used to specify
the speaker line.
'Start SD-Sound'
A positive edge on the corresponding input runs a call of the file name
'#Wave/Key ID' from the station 'of Station'. Only the local station is supported
at the current time. To start an SD audio file from a remote station, the function
'Emulate Keypad Key' is used.
'GP' flag:
● If set, then: Feeding of Audio Input 1 depends on Logic Input
● If not set, then: Feed Audio Input 1 as configured
'Stop SD-Sound'
Stop the playback of the station 'of Station'.
'Trigger Audio Channel'
If defined, audio is only fed into the network if this contact is active high. Local
audio is always played. To make sure the local outputs behave like the
network feeds, enable the 'GP' flag.
'GP' flag:
● If set, then always play the Local Audio Output
● If not set, then Local Audio Output depends on Logic Input
'Emulate Keypad Key'
Use parameters 'KeyID' to select requested Key and 'StationID' to select the
Requested Station. The 'GP' Flag is used in this mode if the 'Talk Button' is
automatically selected.
'GP' flag:
● If set, then the 'Talk Button' is also emulated
● If not set, then the 'Talk button' must not be emulated
'Enable Alarm Keys'
This is used together with the 'Desk call stat. (19 buttons)' and a key switch, so
an evacuation call cannot be triggered inadvertently. Buttons with the 'ALARM
KEY' flag on the 'Desk call stat. (19 buttons)' keypad can only be pressed if
this input is in the logic high state.
Running on Battery
When the station is running on battery, this function can be used to save
power (e.g., background music is muted). Click on the relevant checkbox in
the 'GP' column to distribute this information in the network.
'GP' flag:
● If set, then: information over the network is distributed
● If not set, then just local use of information