Configuration Instructions

Hardware specific configuration
'Logic Outputs – Connector'
7
152 | 219
A6V10429097_en--_e
'Output'
Read-only value of the respective output.
'Name'
The 'Name' parameter could be used to add a text description for the selected
output.
'Enabled'
Use this checkbox to activate the corresponding output
'Invert'
Use this checkbox to invert the physical state of the output
'Function'
The 'Function' defines the behavior and the functionality of the given output as per
the following table:
Function
Description
'Local Logic Input'
'Local Logic Input' is used to set the output. The requested input number is
configured by the 'Input/SysVarID/Feed/Level/Led' column.
'Remote Logic Input'
A digital input from Station with selected ID is used to set this output. The
requested input number is configured by the 'Input/SysVarID/Feed/Level/Led'
column.
'Active Call'
A priority channel based call is active on the corresponding audio output, which is
selected via the AudioOutput column.
Example: Logic output 1 is enabled if a priority call is active in the local
AudioOutput 1.
'System Variable
(SysVarID)':
'SysVarID' is used to set the corresponding output. The requested parameter is
selected via the 'Input/SysVarID/Feed/Level/Led' column.
1
TalkbuttonPressed
2
ActiveCall
3
stopSoundKey
4
startSoundKey
5
voice alarm Active
6
voice alarm silencing active
256
Network ring failure (ERPS) detected, global system feature without the
use of a specific station ID
'System Fault'
Output is used to detect system errors. Depending on a configured RSBL this
output reports relevant errors of the RSBL-Stations (Mic failure, missing
stations,…). Error logging must be active to use this function.
0
Local errors, of the own network matrix
1
Errors of all monitored devices in the RSL (error logging must be active)
2
Global system fault.
'System Fault Buzzer'
Same functionality as the 'System Fault' function, but the output state can be
cleared by an existing 'Test & Quit key' (see section on digital inputs).
'GP_OUT'
This output could be generally used as general purpose output. You could use the
API to control this output.
'WD_OUT'
reserved