Configuration Instructions

Hardware specific configuration

'Logic Outputs – Connector'

A6V10429097_en--_e

155 | 219

'Input/SysVarID/FeedNo/Level/Led'

is used as parameter depending on the selected function.

'Audio Out/In'

is requested for some functions to select the requested audio output

'LED Mode'

Color parameters must be defined for certain output functions. The set color

determines the behavior of the output, for 'Keypad LED', for example.

Valid combinations are shown in the table below:

'Any'

The output will react on any LED color

'Red'

The output will react only if the red LED color is present

'Green'

The output will react only if the green LED color is present

'Yellow'

The output will react only if the yellow LED color is present

'Of Station'

Enter the ID of the target station for the predefined function in this field. This option

is only mandatory for some functions.

'Pulse Mode'

If enabled, all changes of an output will cause a short pulse on the output. The

length is determined via the parameter 'Pulse Time on activated Pulse Mode'.

Pulse time: 0.1 s...25.5 s

'State'

Corresponds to the physical state of the logic output as follows:

● L = low, LED off

● H = high, LED on