Configuration Instructions

System configuration
Setup the supervision extension card
5
56 | 219
A6V10429097_en--_e
Parameters
Description
'RMS'
Voltage of the pilot tone in [V]
'Impedance'
Magnitude of the complex impedance |Z| at the pilot tone frequency in [ohms]
'SNR'
EOL1..2 response power in [dB]
'State'
State of the line, e.g., OK, BREAK, SHORT…
'EOL3'
IDs of the detected EOL modules, if a sweep was started
5.5.3.2 Performing an impedance measurement
◈
Select 'Measure Impedance' and 'Linedetection (Chx)' for a line.
 The measurement process starts and the result is displayed.
Fig. 24: Impedance measurement
At the lower end of the display the rated power is displayed at the cursor location.