Configuration Instructions

System configuration
Setting up a loop isolator speaker system
5
62 | 219
A6V10429097_en--_e
Example 2: Loop 1 in 'BREAK' state
Fig. 30: 'LineDetection' statistics example 2
Speaker line 1 RMS 28 V
Impedance 1044 ohms at 20 kHz
Speaker line 2 RMS 29 V
Impedance 1044 ohms at 20 kHz
● Voltage is above 25 V = very good
● A slight voltage increase can be measured, no impact on the functionality
● The impedance in line 1 is much higher than in line 2 (1044 > 160). This means
that the isolated segment is very close to line 1 (start, IN) of the loop.