Configuration Instructions

System configuration

Setting up automatic volume control (AVC)

A6V10429097_en--_e

65 | 219

Fig. 32: Calculation of the AVC attenuation value

Fig. 33: Other network participants utilizing the AVC attenuation value

To configure the AVC system, follow the steps described. First

you need to configure the noise monitor.

1. Open the audio input configuration page

2. Configure the fourth audio input. Name it 'AVC-MIC my zone name'

3. Set the type to Mic and adjust the gain, so the measured value is below -40 dB

if the environment is silent