Configuration Instructions

System configuration

Configuring desk call station PT2009

76 | 219

A6V10429097_en--_e

5.16 Configuring desk call station PT2009

Setup the analog audio input

1. Set the level of the first audio input to line level and adjust the input gain. The

default setting is +0 dB.

– Values may vary dependent on the length of the network cable used

2. Disable the phantom power

3. Configure the first audio input of the matrix as the priority channel by assigning

a channel number >128.

4. Optional configure an input EQ to minimize the risk of acoustic feedback or to

further decrease the input gain

Setting up the 'PACE-Bus' common configuration

◈

Set the Number of used KeyBlocks to the number of call stations. Example:

2 call stations = 2 button blocks

Setting up the 'PACE-Bus' device-specific configuration

1. Choose a PT2009 from the 'Device ID' drop-down list field.

2. Route the call station buttons to the keypad blocks. Example: call station 1 =

block 1, call station 2 = block 2

Setup a virtual call station

1. Open the configuration page 'Station' > 'Configure Virtual Keypad'

2. Configure a 'TALK', 'SELECET ALL', and 'SELECT NONE' button on the main

keypad

3. Switch to the last keypad extension – 'Extension 4' – and configure the keypad

blocks by configuring the 'ZONE SELECT' buttons.