Configuration Instructions

System configuration

Using an output from separate call stations

A6V10429097_en--_e

95 | 219

5.19 Using an output from separate call stations

A digital output should be controlled from two separate call stations. The LED of

the function key should light up if the status is (ON).

Configuration of call station A:

1. Configure a keypad key with the function 'Switch L>H' (acts as a common

status indicator, sharing the boolean information OFF/ON).

2. Configure a keypad key with the function 'Macro mode' and enable the

'USE_MACROS' flag.

Setting macros for the PRESS event

'LedState' of call station A, 'any LED' set to 'Switch L>H'

'Emulate Key' of call station A set to 'Switch L>H'

Setting macros for the RELEASE event

'Emulate Key' of call station A set to 'Switch L>H'

'Emulate Key' of call station B set to 'Macro Mode'

Configuration of call station B:

◈

Configure a keypad key with the function 'Macro mode' and enable the

'USE_MACROS' flag.

Setting macros for the PRESS event

'LedState' of call station A, 'any LED' set to 'Switch L>H'

'Emulate Key' of call station A set to 'Switch L>H'

Setting macros for the RELEASE event

'Emulate Key' of call station A set to 'Switch L>H'

'Emulate Key' of call station A set to 'Macro Mode'

Configuring a logic output for a network matrix:

1. Activate the 'Enabled' checkbox.

2. Set the function to 'Keypad Led'.

3. Set 'Station' to the station ID of call station A.

4. Right-click in the field 'LED Index Field' (default value = 1) and set to 'Switch

L>H'.